ACOMNIRPSMA
2.4Ghz 5dbi Dipole Antenna with RPSMA connector
ราคายังไม่รวม Vat 7%
Tel :095-5544841, 02-7698200
E-Mail : sales@wireless-guru.com
line : @wireless-guru
2.4Ghz 5dBi Dipole antenna with RPSMA connector.
ราคายังไม่รวม Vat 7%
Tel :095-5544841, 02-7698200
E-Mail : sales@wireless-guru.com
line : @wireless-guru
258.00 ฿
CompareACOMNIRPSMA
2.4Ghz 5dbi Dipole Antenna with RPSMA connector
ราคายังไม่รวม Vat 7%
Tel :095-5544841, 02-7698200
E-Mail : sales@wireless-guru.com
line : @wireless-guru
brands | Mikrotik |
---|
S+RJ10 module is supported also on devices with passive cooling, but may require an extra cooling.
The latest revision of S+RJ10 contains “/r2” by the end of serial number. It comes with following improvements:
– Jumbo frames up to 10218 Bytes are now supported for rates 2.5Gbps, 5Gbps and 10Gbps;
– Link speed reporting is fixed – actual link speed in the interface menu is listed. Previously 100M/1G/2.5G/5G link speeds were not reported correctly;
– DDM monitoring (Supply Voltage, Module temperature) is now supported.
The board features 9 wired ports and a full-sized USB 3.0. Seven of the ports are Gigabit Ethernet, another one is 2.5 Gigabit Ethernet, and the last one is a 10G SFP+ cage. All the ports are connected to a powerful Marvell Amethyst family switch-chip with a 10 Gbps full-duplex line leading to the Marvell Armada Quad-core ARMv8 1.4 GHz CPU. Both CPU and the switch-chip are located on the bottom of the board – so the case acts as a massive heat-sink!
RB5009UG+S+IN can be powered in 3 different ways:
a) PoE-in from Ethernet port #1
b) DC Jack
c) 2-pin terminal on the side
The “Improvise. Adapt. Overcome.” mindset can be very helpful, but sometimes you simply need a device that works and solves the problem without additional tinkering. The CCR2004-1G-12S+2XS does just that – forget about all connectivity troubles and expand your setup in any way you please. This handy router features 12 x 10G SFP+ and 2 x 25G SFP28 ports.
The GPeR unit allows to extend Ethernet cable by additional hop (< 100 – 150 m to regular network devices, and up to 210 m to another GPeR unit) up to 1,500 m.
Handy for highrise buildings, multi-apartment buildings, with many floors and sections, where very long Ethernet cables might be a problem.
Maximum allowed length of CAT6 Ethernet cable between GPeR and power source/router is up to 100 m (depending on cable quality, high quality – up to 150 m).
Maximum allowed distance of CAT6 Ethernet cable between two GPeR devices is up to 210 m (depending on cable quality).
In case if the destination device does not support PoE-in powering, the PoE Passthrough can be disabled by manually removing all jumpers.
There are no reviews yet.